Brice's 05 GT M5 with Whipple HO kit at 10psi 497RWHP/472RWTQ

[Justin@VMP]

Brice is known in the area for having one of the fastest bolt on 05+ GTs at the track. His car consistently went high 12s with just a KN intake and VMP Mail order tune, on stock rubber.

He added a new clutch, driveshaft, and Intercooled whipple HO blower kit (gen2, 3.5" pulley, makes just over 10psi). Stock cats and stock mufflers. The IAT has been properly relocated to pick up the temperature of the air going into the engine, so the computer can adjust timing accordingly.

With a few small tweaks to VMP's standard whipple tune the car made great power. Even on a back to back pull it kept on putting out. I keep telling Brice that he will be really dipping into the 11s with this setup at the track, and will have one of the quicket stock motor blown 05+ cars.

http://www.vmptuning.com/dynographs/brice05gtwsc.jpg

[BriceS]

Hey Justin,

Just wanted to stop by and give you an update on how the mustang is running at the track. Last wednesday I set a new best running an 11.417 @ 122.08 with a 1.676 60' time. This was on the last run of the night after which I was kicked off for no roll bar. The first run netted me an 11.428 @ 120.71 with a 1.617 60' time. I am still running the same setup when you had dynotuned the car with the exception of a better clutch. Still all stock exhaust. I am researching at the moment, but I believe that the 122 mph is the fastest trap speed accomplished by a 05+ stock block 10 psi pullied whipple! And this was done running only 93 octane pump gas! It may also be the fastest ET for 10 psi as well. I will be heading out to the track tonight as the weather will be much colder than wed and am hoping to see 123 mph!

Here are the videos.

11.41 @ 122.08
http://www.youtube.com/watch?v=r1MbAE4449E

11.42 @ 120.71
http://www.youtube.com/watch?v=Pt00dpJNBiA

[BriceS]

Update:

Got back from the track and ran a new best:

11.365 @ 122.72 w/1.663 60'
http://www.youtube.com/watch?v=BoGf6DiMVk4

[Justin@VMP]

Awesome!